Professional Painting Contractors Forum banner

spackle or putty

58K views 14 replies 14 participants last post by  painttofish 
#1 ·
Hi Guys I need a dispute settled. I was taught in the 70's and we always puttied nail holes in the trim on new work with DAP 33. New guys in the trade want to use spackle and sand it down. I say use putty and no sanding. What do you guys use on nail holes. MOPAINT
 
#7 ·
In new construction we always used Dap mixed with drywall dust (or babypowder). Real easy & fast.

On higher end homes I reather use something sandable so we don't have any possible dimples. They are paying for the few minutes it takes to sand though. ;)
 
#8 ·
I use light weight spackle with a sand. Allthough... I have used light weight spackle with out sanding. It goes on and wipes of really nicely, with minimal sanding effert. Just be sure to get the hole filled so that you don't have any cat-eyes. :thumbsup:

J
 
#10 ·
Dap - are you guys talking window glazing? That stuff takes weeks to dry! Muralo has an interior/exterior spackle that is the bomb. It ain't lightweight like fast 'n final - but dries so fast withe absolutely no shrinkage. Personally I kill two birds with one stone by giving the trim a whole sand down prior to priming - so the spackeld spots get sanded as well.
 
#13 ·
Crawfords putty and a putty knife to cut it off. leaves a little "skin" if done right and a light sanding is usually all that is required, especially if brushing. If spraying detail, like a mantle, built-ins, heads, crown etc then I'll possibly give a light touch of MH ready paste and a sanding.
 
#14 ·
In the 70 s and 80 s we used dap 33 also but it always showed where the hole was. now we use the drydex and then lightly sand it most of the time you will never see where a hole has been unless its nailded in mdf board. But It is easy to over look when you go to sand it off ,If you dont have alot of light in the house.
 
#15 ·
What I have started recently is to take a spackle paste like crawfords and mix in some lightweight spackle to a 50/50 ratio or so. This reduces the mess of lightweight and makes the sanding easier than straight paste.:thumbsup: I find MH to hard to sand for nail holes. Works good for small patches, dings etc.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top