Professional Painting Contractors Forum banner
1 - 12 of 12 Posts

· Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
any advise on painting stair well spindles? the top rail will remain staind, just painting spindles... i work with designers and do lots of painting, have an airless.., but never encountered spindles. im not sure if they can be taken out-- oh yea the spindles are all turned with a medium amount of detail. this is a repaint so i would be afraid of spraying inside.. thanks...
 

· MASTURPAINTER
Joined
·
138 Posts
hi. i'm assuming there's no carpet. if the staircase has a balustrade you're going to need a long handled bent brush (2 inch) to get between the apron and outer string; ab 1 and a half inch, and i always carry a lining fitch (anything over 3/4 inch) a flat fitch gets into small places and can cut into bottom of handrail very sharply if you need to. I always work with at least two brushes, sometimes three. staircases are better with one either side. but there is a system to painting them well, this comes with practise. keep notes on how you could have done it more efficiently for ron - later on

paul
 

· very senior member
Joined
·
9,850 Posts
My partner would be one side and I on the other. Brush work. It worked well for us.

Works great,if you have a partner,if not, you just have to move fast and often,good exercise,and the wife says I don't get a cardio workout.:whistling2:
 

· PinheadsUnite
Joined
·
30,726 Posts
My partner would be one side and I on the other. Brush work. It worked well for us.

Works great,if you have a partner,if not, you just have to move fast and often,good exercise,and the wife says I don't get a cardio workout.:whistling2:

Yah, can't count the number of times facing spindles by myself and wishing "Little Sh!t" was there.

-Bill
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top