Professional Painting Contractors Forum banner
1 - 8 of 8 Posts

75 Posts
Discussion Starter · #8 ·
What the magic is this? looks fantastic, i should learn how to work with the stain. It was sprayed?
When Im refinishing I do sending to bare wood. Then stain with sponge rag for stain. Then I stain brush to make some lines. After that I sprayed the same stain "really smoothly and easy barely spraying" with airless gun. Then after it dries, 2 coats, I sprayed using KRYSTAL High-Solids Conversion Varnish smooth and easy but Not hard. Then I sanded for leaks and other bumps easy and smooth. Vacuum all the sanded stuff. Then I spray full Krystal Vernish 3 coats. It drys pretty quick. I sand and vacuum after every coat but final. I use sponge sander. After it is all ready and the Vernish is dry I use decorative oil glaze with brush. clean it up with piece of clothing to take some of the glazing off a bit if its too much. use your fantasy and imaginations in glazing.
hope that helps.
and by the way a quick tip when sanding use an old sponge sander not new one because it will tear off and will mess it up.

you are done! wait till it drys and clean up!
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.