Professional Painting Contractors Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,488 Posts
No direct experience, so just spit balling.

Maybe tip it on its side, squirt a few drops of something like goo gone on the lower bumpers. Let it soak a bit w the help of gravity. Then work it with a razor, sharp putty knife, or 5 in one. Roll it to the next side and do the same - x4 sides. Get those old gummy bumpers loosened up. If you don't have a helper, have it tipped up close to a wall or something so that if it ever does decide to just pop it can't just fall right out and splat on the floor.

Short story? I'd probably just go low and and slow. Patience, a little solvent and and little coaxing.
 
1 - 1 of 1 Posts
Top