[The paint whisperer]

I have not use or work with this type of products.
I did some reading on their website and it seem to be all about preparations
(nothing new, nothing over my head).
Beside removing the old coating/sealer, clean... any concern that i should be aware of?
I just want to hear from anyone who has work Whith it before.

 

[oakley]

I have used a similar product at this time last year and the main concern was temperature. Drying times are increased exponentially as the temperature decreases.

 

[T200]

- Do a moisture test on the concrete first. Tape down a piece of plastic using duct tape...about a 1-foot square piece. Check it after a few days to see if there's any moisture under it. If so, the floor should be sealed before applying the epoxy. I didn't do this and ended up with a small area that bubbled.

- Follow the instructions! DO use a mechanical stirrer to mix. Allow whatever the time is before applying it (30 min., I think). Pot life is only a couple of hours...don't mix too much at a time.

 

[The paint whisperer]

Anyone else?

Thanks