Professional Painting Contractors Forum banner
1 - 1 of 5 Posts

· Registered
79 Posts
Discussion Starter · #1 ·
We're bidding a large warehouse job - looks like we'll we awarded. The GC wants us to apply the coatings on the concrete slab as well (153,000 sf). I'm trying to decide if there's a better method of application other than 2-3 crews pumping through our Graco Mark 5's with standard gun & tip set up (prob 517 tip or thereabout) and a 2' extension.
We've done a ton of slab sealing but nothing this large. We normally roll with an 18' roller or poor out a ribbon and squeegee across the surface. That ain't gonna work here - way too much surface area.

All input welcome.

Thanks everyone


1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.